Australia

Home › Floor coverings › Installing › Solid timber

Solid timber over Warmboard

19 mm boards, nailed or glued

Recommended: 19 mm solid boards

Warmboard Inc recommends 19 mm solid timber over its panels, and reports more than 3.7 million m² laid over Warmboard since 1998. Thicker boards spread the heat more evenly, so you can’t feel where the pipes are.

All timber moves with humidity. Quarter-sawn or rift-sawn boards are more stable, and the right moisture content at installation limits movement.

Timber flooring being nailed over Warmboard panels with a flooring nailer

Acclimatisation

  • Before the timber arrives:
    Plastering finished and dry, and the heating run for a couple of weeks to dry the panels.
  • Moisture:
    Panels at 12% or less. Timber at the content your flooring installer recommends for your climate.
  • On site:
    Open the packs and stack the boards on spacers so air moves around them.
  • Bringing the heat up:
    Run warm water for a few days after laying, then raise the temperature gradually (for example 38 °C, then 49 °C).
  • Long term:
    Indoors at 15–26 °C and 30–50% relative humidity.

Fixing methods

Nail

Lay boards across the pipe pattern where you can. Secret-nail at 45° and 150 mm centres. Where boards run along a pipe, glue or face-nail instead.

Nail and glue

Apply an approved adhesive with a trowel or gun, then nail. Where boards run along a pipe, the adhesive alone holds them.

Glue

Glue straight to the panels with an approved adhesive. Nothing else is needed between.

Floating

Click-lock or edge-glued boards laid loose over a low R-value underlay suited to floor heating.

Approved adhesives

Use an adhesive on Warmboard Inc’s approved list: Bona R850T, R851, R859; Bostik BEST, BST, Climb, EFA+, GreenForce, HDAC, ProCure, Pro-MSP, Ultra-Set SingleStep 2, Vapor-Lock; Mapei Ultrabond Eco 975, 980; Sikabond T-35, T-55; Stauf PUK-455, PUM-950; Titebond 771, 811, 821; Wakol MS 230, 232, 260, 262, 290, 292, 245/246, PU 224, PU 385. Using another adhesive voids the product warranty.

Ready to plan your floor?

Send us your plans. Warmboard’s design team will draw your panel layout and pipe loop plan, and we’ll prepare your quote.